Author Topic: Problems with curves Tool in Linework layer  (Read 2253 times)

minticeTopic starter

  • Newbie
  • *
  • Posts: 1
  • YearsYearsYearsYears
    • View Profile
Problems with curves Tool in Linework layer
« on: December 18, 2017, 05:48:02 AM »
I usually use the 'Curves' tool in a linework layer, and modify the lines while pressing Crtl. When clicking Ctrl , I could edit the linework But, I did something wrong and if I click again Ctrl, the entire lines are moving and they are red now...So i can't edit one by one as I was doing before. How can this be normal again?