Author Topic: Help with the magic wand tool?  (Read 3961 times)

batmanloveTopic starter

  • Newbie
  • *
  • Posts: 3
  • YearsYearsYearsYears
    • View Profile
Help with the magic wand tool?
« on: December 28, 2010, 11:04:59 PM »
When I try to select a section with the magic wand the WHOLE page gets selected when I need to select only a portion of my drawing! What should I do?

sos?  :'(

restorer

  • Administrator
  • Sr. Member
  • *****
  • Posts: 438
  • We are from osaka ^_^
  • YearsYearsYearsYearsYearsYears
    • View Profile
    • Zame software development
    • Email
Re: Help with the magic wand tool?
« Reply #1 on: December 29, 2010, 12:12:35 AM »
Try to change detection mode:


batmanloveTopic starter

  • Newbie
  • *
  • Posts: 3
  • YearsYearsYearsYears
    • View Profile
Re: Help with the magic wand tool?
« Reply #2 on: December 29, 2010, 01:09:48 AM »
what specifically about it? like, the transparency or the color difference because I've tried changing the color difference all the way down to zero and it hasn't done anything, should I try moving the color difference up?

restorer

  • Administrator
  • Sr. Member
  • *****
  • Posts: 438
  • We are from osaka ^_^
  • YearsYearsYearsYearsYearsYears
    • View Profile
    • Zame software development
    • Email
Re: Help with the magic wand tool?
« Reply #3 on: December 29, 2010, 03:42:09 AM »
So you say that you try to set mode to "transparency (strict)", "transparency (fuzze)", and "color difference" - but in all modes you can't select part of image?
Post your image here, I will try.